A surveyor in a respirator putting a sample of loft material into a sealed bag

Oxfordshire · England

Artex Removal for Binfield Heath

Artex removal across Binfield Heath, for houses, flats and commercial buildings. Every job is quoted in writing.

  • Ceilings due to be knocked through or removed
  • Damaged or cracked coatings
  • Ceilings before downlights go in

Ask for a quote Call 07833 053 749

Artex removal near Binfield Heath

Artex removal in Binfield Heath

For an asbestos coating, the room is sealed, the coating kept wet and nothing sanded or dry-scraped, with the waste bagged and taken to a permitted site. People often contact us about ceilings coming down and landlord refurbishments, including swirl patterns, textured walls and coated ceiling roses.

Village homes like those in Binfield Heath have often been altered several times, so ceilings may have been coated during an earlier renovation. You get written paperwork for every job: a report, laboratory results or a waste consignment note, for your records.

A sealed sample bag held up by a surveyor
Area
Binfield Heath (RG9)
Area hub
Oxfordshire
Service
Textured ceilings and walls
Afterwards
Result and waste note
Price
A written quote before work starts
Telephone
07833 053 749
Updated
26 October 2026

A closer look at the materials

Coated plasterboard

Board removal avoids stripping.

Patched areas

Different areas may need separate samples.

Common reasons for Artex jobs in Binfield Heath

Leaks and DIY can damage coatings, which can make them crumble.

You can’t tell by looking, but these are common reasons people contact us:

  • Textured walls before a refit
  • Landlord refurbishments
  • Flaking textured ceilings
  • Ceilings due to be knocked through or removed

For rented flats close to Shiplake station, textured ceilings can be tested between tenancies.

What to look for in a quote

  • What paperwork you get
  • What category of work it is
  • Whether VAT is included
  • Proof of an HSE licence where it’s needed

Choosing an asbestos contractor

Textured ceilings in Binfield Heath

Binfield Heath is about 2 miles north-east of Caversham, in Oxfordshire. Properties in Binfield Heath range from older houses to newer estates and commercial buildings, and anything built or refurbished before 2000 can contain asbestos. We cover 443 places across Oxfordshire.

For a school such as Shiplake Church of England School, the duty holder’s records should show any coatings. In older homes in Binfield Heath, textured ceilings were often added in later decades.

This part of Oxfordshire takes in RG9. We can help with Artex jobs on streets such as Kings Common Close, Heathfield Avenue and Kiln Lane or the roads around them. Close by, we cover Shiplake Cross (1 mile east), Harpsden Bottom (2 miles north), Harpsden (2 miles north-east), Henley-on-Thames (2 miles north) and Sonning Common (3 miles north-west). Within a short drive, we also work in Benson (11 miles north-west), Chinnor (14 miles north), Tilehurst (5 miles south-west), Wallingford (11 miles north-west), Little Heath (6 miles south-west) and Oakley (14 miles north).

Other landmarks nearby include Royal Berkshire Hospital (3.7 miles south) and Frazer Nash Archives (2.4 miles north-east). Green spaces nearby include South Lake and Alder Moors.

  • Local schools include Gillotts School (1.7 miles north)
Map of Binfield Heath © OpenStreetMap contributors

Your questions about Artex removal in Binfield Heath

Do you come out to small villages like Binfield Heath?

Yes. We cover villages and hamlets as well as towns. Tell us about access and parking.

Is the Artex in my Binfield Heath home asbestos?

Some may, but many coatings do not contain asbestos. Only a test will tell you.

Do you need a licence to remove Artex?

HSE’s code of practice says it will not normally be licensable. Larger steam or gel jobs must be notified first.

What if my house is newer?

Asbestos was banned in 1999, so a home built after 2000 shouldn’t contain it, though older parts, reused materials or earlier outbuildings can.

Can I plaster over Artex that contains asbestos?

Skimming or boarding over an intact coating avoids disturbing it, but never sand it first, and keep a record.

Which asbestos work needs a licence?

Licensed work is work on the materials most likely to release fibres: lagging, sprayed coatings and most asbestos insulating board. Only a contractor holding an HSE licence can do it.

Is damaged asbestos an emergency?

First, keep people away from the damaged material: shut the door if you can and do not sweep it up. Then contact us for advice on the next step.

Is it OK to scrape off Artex?

Not before testing. Sanding or dry scraping an asbestos coating releases fibres.

What happens next

After removal, the room is cleaned and the waste goes to a permitted site, with a consignment note.

A few practical points:

  • Keep pets away
  • Test every different coating
  • Tell us which rooms and roughly how big they are
  • Empty the rooms in advance

Things not to do

Don’t try DIY removal products on untested coatings.

Hold off on drilling until you have a result.

Should you do it yourself?

Found something mid-DIY? Stop: keep people away, do not sweep or vacuum it up, and get advice.

Sanding, drilling, cutting and jet-washing are the worst things you can do to asbestos materials, so avoid them completely.

How we price Artex removal

We base our quote on:

  • The size of the job
  • What the material is and its state
  • Disposal costs
  • Parking and access charges

Very low prices can mean corners are being cut: proper controls, lab analysis and legal waste disposal cost money.

Helping us quote

A few photos can save a site visit:

  • Any damage, cracks or broken pieces
  • A closer photo of the material, without touching it
  • A rough size or measurement
  • Any labels or markings, if you can see them safely

For a quote, use our quote form or call 07833 053 749. Include the postcode, the material and some photos.

Limits to be aware of

Some limits to bear in mind:

  • Larger-scale steam or gel removal must be notified before it starts, so allow time
  • The room being worked on has to be empty and sealed off
  • Other asbestos materials found in the room are dealt with separately

If you are unsure, describe the job and send photos, and we’ll advise before booking.

Common materials

  • Ceiling roses and cornices (coated)
  • Coated plasterboard
  • Swirl and stipple patterns
  • Artex ceilings
  • Textured walls
  • Patched or painted coatings

Service details

For businesses and landlords in Binfield Heath

Community buildings count as non-domestic premises, so whoever runs them has a duty to manage asbestos.

If you own a block of garages or outbuildings that you let should know what the roofs are made of, before repairs are arranged.

The process

For board removal, we take the boards down in whole pieces. Parking close by makes the day easier.

  1. Tell us which rooms and surfaces
  2. We test the coating if it hasn’t been tested
  3. If it contains asbestos, we agree the method and quote
  4. The coating is removed with controls
  5. We clean up and send the waste paperwork

How to prepare

  • Let neighbours know if the work is near them
  • Let us know where we can park
  • Move belongings away from the area, without touching the material

Getting a price

For an accurate quote, tell us what you’ve found, where it is and what you’re planning. Then call 07833 053 749 or use our quote form.

Tell us what you need

Related guides

  • Survey or test first when it isn’t clear what a material is
  • Work planned to the Control of Asbestos Regulations 2012 and HSE guidance
  • Paperwork for your records: reports, lab results and consignment notes
  • Asbestos waste double-bagged or wrapped and taken to a permitted site

How it works · Licensed or non-licensed? · Get a quote