Oxfordshire · England
Artex Removal for Hook Norton
Any pre-2000 building in Hook Norton may contain asbestos. Our artex removal service covers testing and removal of Artex and textured coatings.
- Damaged or cracked coatings
- Extensions that cut into ceilings
- Ceilings due for rewiring or new downlights
Artex removal near Hook Norton
Artex removal near Hook Norton
According to HSE, textured coating work is normally non-licensed. Bigger jobs using steam or gel must be notified before they start. Common materials are Artex ceilings, swirl patterns and coated plasterboard, and people typically contact us about damaged or cracked coatings and ceilings due for rewiring or new downlights.
In places like Hook Norton, textured ceilings are a common renovation find, and testing comes first. We identify materials before planning removal, because the method depends on what the material is.
- Area
- Hook Norton (OX15)
- Area hub
- Oxfordshire
- Covers
- Testing and removal of textured coatings
- You receive
- Lab result and consignment note
- Quotes
- A written quote before work starts
- Call
- 07833 053 749
- Page updated
- 26 October 2026
For landlords, agents and businesses
Letting agents often ask about asbestos before maintenance work. A test or survey gives a definite answer.
Void periods are a good time for asbestos work, when rooms are empty and work can be done without disruption.
Nearby places to Hook Norton
Other services in Hook Norton
Artex in Hook Norton homes
Hook Norton is about 7 miles south-west of Banbury, in Oxfordshire. Hook Norton is part of the area we cover, from older terraces and semis to flats, workplaces and outbuildings. Hook Norton is one of 443 places in Oxfordshire where we work. We work right across the region, from Hook Norton to Oxford (about 20 miles away).
In older homes in Hook Norton, textured ceilings were often added in later decades.
Wherever your property is in OX15, we can help with Artex removal. Streets in the area include High Street, Station Road and Chapel Street, and Artex removal is available on all of them. Close by, we cover Swerford (2 miles south-east), Wigginton (2 miles east), South Newington (3 miles east), Little Tew (3 miles south-east) and Great Tew (4 miles south-east). Within a short drive, we also work in Banbury (7 miles north-east), Bicester (15 miles south-east), Witney (15 miles south), Kidlington (15 miles south-east), Bure Park (15 miles south-east) and Chipping Norton (5 miles south-west).
Other landmarks nearby include Broughton Castle (4.8 miles north-east) and Old Forge Museum (Great Tew) (3.5 miles south-east). Open spaces near Hook Norton include Woodford Bottom and Lamb's Pool.
- Pubs nearby include The Bell Inn (under half a mile south-west)
Common reasons for Artex jobs in Hook Norton
Renovations disturb coatings: sanding, dry scraping or drilling.
These are some of the things we deal with in Hook Norton:
- Coatings damaged by leaks
- Walls before tiling
- Ceilings before downlights go in
- Ceilings before skimming
A school like Hook Norton Church of England Primary School should know from its asbestos register whether coatings have been tested, before decorators start.
Before you book anyone
- How the work will be done, and the controls used
- Laboratory analysis by an accredited lab
- VAT, clearly stated
- Whether the job needs notifying
Can I do it myself?
Found something mid-DIY? Stop: leave the area, don’t clean it up, and ask for advice.
DIY sampling means disturbing the material yourself. HSE advises that samples are best taken by a competent person.
How it works
We start by sealing and protecting the room, then keep the coating wet throughout. Before we start, we walk through the job with you and answer any questions.
- Describe the coatings and rooms
- We test the coating if it hasn’t been tested
- We plan the removal and send a quote
- We seal off the room and remove the coating wet
- The room is cleaned and you get the paperwork
Before we arrive
- Tell us about parking and access
- Move belongings away from the area, without touching the material
- Dig out previous surveys
Ask for a quote
We quote each job individually, because no two are the same. To start, use our quote form or call 07833 053 749.
Helpful guides
Weighing up your options
You will find DIY products for removing Artex, but if it contains asbestos, the job needs proper controls. Test first. Sometimes a test shows removal is not needed, if the material turns out not to contain asbestos.
Why choose us
- Honest advice, even when the answer is to leave it
- Legal disposal, with paperwork
- Reports and results you can share
- Covering London and the South East
Read our prices page and the cost guide.
A closer look at the materials
Painted coatings
The sample includes the coating itself.
Artex ceilings
We test each different coating.
After the job
Covered coatings should be recorded.
If asbestos stays in the building:
- Test every different coating
- Plan around the closed rooms
- Photos help us quote
- Book your plasterer after removal
Avoid these
Don’t sand, scrape dry or wire-brush a textured coating before it’s been tested.
Do not sand, scrape dry or wire-brush a textured coating before it’s been tested.
Hook Norton questions
Do textured ceilings in Hook Norton homes contain asbestos?
Some may, but many coatings don’t contain asbestos. Testing a sample is the only way to know.
Could my house in Hook Norton contain asbestos?
Any home in Hook Norton built or refurbished before 2000 can contain asbestos, but only a test can confirm it. Garage roofs, Artex, floor tiles, soffits and flues are typical examples.
What’s the difference between a test and a survey?
Testing tells you about particular materials; a survey looks at everything in scope, including things you hadn’t spotted.
Can you advise before I buy a property?
Yes. A pre-purchase survey, arranged with the seller’s permission, shows what asbestos is there before you exchange.
Do you work for landlords and businesses?
Yes: homeowners, landlords, managing agents, businesses and contractors. Tell us about the property and what you need.
What if asbestos is found during building work?
The builder should stop and close off the area. We will identify it and advise on removal.
What does licensed work mean?
Work on higher-risk materials, such as lagging, sprayed coatings and most insulating board, is licensed and must be done by an HSE-licensed contractor. Cement and textured coatings usually are not licensed.
Will I get the price in writing?
Always: you get the scope and price in writing, and whether VAT is included.
The scope of Artex removal
Here’s what Artex removal covers, and what it doesn’t:
- We test before removal, since a negative result changes everything
- Big jobs need notifying in advance, which affects the start date
- We leave the surface ready for your plasterer
If in doubt, ask: we’ll recommend a test, a survey or removal before booking.
What we deal with
- Textured walls
- Coated plasterboard
- Patched or painted coatings
- Ceiling roses and cornices (coated)
- Swirl and stipple patterns
- Artex ceilings
- Nothing removed blind: unknown materials are tested first
- Work planned to the Control of Asbestos Regulations 2012 and HSE guidance
- Everything in writing: quotes, reports, results and waste notes
- Waste sealed and labelled, then taken to a permitted site